How to Reset Puff Count and Refill Disposable Vape?
Now, this is not a safe practice; it is not even advised by vape manufacturers, but some inquisitive vapers have really argued that although disposable vapes are meant to be used once and then disposed of, that, in fact, these vapes can be refilled and reused. The basis of this argument is relatable; since these vapes’ got a tank that stores e-liquid, they should be refillable. But then, the manufacturers make these as disposables; they do not make the tank easily accessible. So, if you must access the tank, you must crack up the case, and that’s where the “big deal” lies.
So, this article actually explains how you can reset the puff count of your vape, as well as refill another e-liquid for reasons best known to you. But you’ve got to be careful; this might mean you’ll be totaling your vape if you make any mistakes.
Disclaimer: Everything contained in this article is for information purposes, we do not recommend opening or disassembling a disposable vape, as such practices are strongly disapproved by vape manufacturers.
How to Reset Puff Count in Disposable Vapes
Most disposable vapes simply show you the level of the e-liquid left in the integrated juice tank, they don’t tell how many puffs you’ve made so far –using the device. But then, there are quite a number of disposable vapes that count your puffs! If you own one of those, usually, you could use the display puff count to show off when you’re around your friends or use it as a bragging point in certain gatherings.
The guide for resetting puff counts is for disposables that support the feature. Resetting the puff count takes it back to 0 as though you just bought the vape, when, in fact, you’ve had it for a while.
Pre-Requisites:
· Pen knife
· Pincers (very tiny ones)
· Screwdriver
· Soldering iron
· Flux paste
Step One: Uncouple the Device
First of all, you have to open up the device’s casing. Now, depending on the disposable vape you’ve got, how to do this may vary. For some vapes, you literally need to use a knife to pry the case before you can open it, and for very few, there are clips/screws to lose. Either way, you have to find a way to open your device and expose the inside.
Step Two: Disconnect The +Ve Battery Terminal
After you have opened the vape, be careful with its internal components as they are very fragile. Also, be sure to take note of how each component was fixed and connected. With these notes, proceed below:
· Locate the battery
· Find where the terminals connect to the Printed Circuit Board (PCB).
· Apply flux paste to the +ve terminal and use a soldering iron to disconnect the terminal from the board.
· Find the pressure switch and press it down gently for some seconds. The location of this switch varies on different vapes.
· If you can’t find the pressure switch on your vape, the alternative is to “short the contacts” and purge the device of all residue charge.
· Now, reconnect the +ve battery terminal.
Step Three: Recouple the Device
If you got all the steps correctly in the previous “Step,” then the puff count on your disposable should reset. The procedure above is confirmed to work for most Elf Bar, Oxbar, Geek Bar, and Flum disposables. However, it could work on other vapes too –that have the puff counter feature. Ensure to assemble the vape correctly, following the same pattern as you disassembled it.
Caution: During the soldering, make sure to focus only on the battery terminals connection; if you mistakenly solder any other part of the PCB, you might have, as well, totaled your vape!
How To Refill Disposable Vapes?
The inability to refill disposables has been the selling point of these vapes since inception; you have to dispose of the device once you exhaust the prefilled e-juice. Many vapers have since wished they could be able to refill their disposables, but it seems impossible, at least, for the many of people that tried.
Well, the truth is, you can refill disposables, but the procedure follows a daunting process that requires apt carefulness and a bit of knowledge about electronic devices–the basics, at least. With this approach, you can refill your second-favorite e-juice when you’re done with the main one you bought.
Pre-Requisites:
· Pen knife
· Pincers (very tiny ones)
· Screwdriver
Step One: Open the Vape
First, you have to open up the vape casing. If the vape has a detachable pod unit, then what you need to open is that pod unit. Now, depending on the disposable vape you’ve got, how to do this may vary. For the majority, you literally need to use a knife to pry the case before you can open it, and for a very few, there are clips/screws to lose. Either way, figure out how to open yours to get started.
Step Two: Locate the E-Liquid Tank
You may need to loosen some screws and remove some soft paddings or components before you can access the e-liquid tank on your vape. Regardless, since you have decided to do this, you should carefully disconnect, unscrew, and displace the paddings placed around the e-liquid tank. When you have seen the tank, carefully locate the tank’s valve and refill your juice. Make sure to drop a few drips on the paddings and wick.
Step Three: Reassemble the Device
When you have refilled the tank and saturate the wick, proceed to assemble the tank and then the device itself. Make sure to follow the same pattern as you did when uncoupling the vape’s components to access the tank. Ensure the paddings are reinstalled and the cables are soldered back (if you had to disconnect them to reach the tank) and fasten all screw nails you loosened. Cover the device’s casing, see if it still clicks and stay put. If the device won’t seal back properly, maybe you should use a tap to wrap it around.
Caution: If you didn’t get the connections right while reassembling the vape, well, the device may blow up when you power it, or may not hit at all; worst still, the LED panel or LCD screen may not come up.
FAQs
Can I Refill My Disposable Vape Manually?
Well, disposable vapes are not designed for such; they are meant to be disposed of immediately after the prefilled liquid is exhausted. If you need a vape you can refill, then you should go for mod kits and pod kits, which have replaceable and refillable cartridges. But, if you really want to give it a try, you can DIY and manually refill your disposable; however, this is not always advisable, as it comes with great consequences if not properly done.
Can Puff Counts Be Reset?
Yes, most vapes feature a reset button, which, when pressed, resets the vape’s settings to factory default, including the puff count. Some vapes also feature a separate puff reset button. However, for vapes with a dedicated fire button, resetting the puff count is usually done by pressing the fire button for a longer time, or taping it consistently for a specific number of times.
Put simply, puff counts can be reset, but how to go about it depends on the type and model of vape you’ve got. You may even need to pry some vapes to reset their puff count.
Why Are Disposables Not Meant To Be Opened or Refilled?
As the name suggests, they are meant to be disposed of after use. Also, because they are meant for one-time use, disposable vapes are typically cheaper than mod kits and other vape types that come with refillable cartridges. If you open a disposable vape, you’ll wreck it and find it difficult to reassemble the components, requiring you to still go ahead and get a new one.
Summary
Conclusively, this informational post explains how to reset puff count and refill disposable vapes. However, the instructions provided in this article are not outrightly recommended as they could lead to a greater consequence. Only try these out if you’re aware of the possible consequences of not getting any of the steps right. You can always purchase your disposable vapes on Eightvape at discounted prices; plus, there are bundle deals to pack a good number and never worry about refills.
