Where is The Hit Sensor on a Geek Bar Disposable Vape?
Geek Bar disposables are primarily draw-activated; hence, you’d hardly see them feature a physical fire button. The auto-draw technology is powered by a hit sensor installed in a critical part of the device where it can detect that the user has made a draw and then it activates the coil to heat the prefilled e-liquid.
While this hit sensor is installed to last and serve throughout the device usage, typical of electrical components, the sensor could go bad and cause the vape to auto-fire randomly, prompting you to want to change it for a new one. Also, you may want to know where the hit sensor is on a Geek Bar vape for personal DIY reasons, so you don’t mess things up when you uncouple the device.
Where is The Hit Sensor on a Geek Bar Disposable Vape?
Geek Bar is quite clever in its device build and designs. The hit sensor is embedded into the mouthpiece; it’s discreet, you may not see it actually, but it resides in that mouthpiece area, which allows the sensor to correctly detect when the vape user makes a draw. The sensor is usually a miniature pressure-sensitive switch that activates when you put your mouth on the mouthpiece and attempt to draw.
The sensor detects the draw you make and triggers the embedded mesh coil to heat up the prefilled e-liquid, and there goes the puffs. This process happens in microseconds and vapor is produced immediately, upon your exhale. So, if you make a draw and there’s no vapor coming out, chances are that the hit sensor is bad or you need to add more pressure to your draws to trigger the sensor and coil.
Symptoms of a Faulty Geek Bar Hit Sensor
When the hit sensor on a Geek Bar vape is faulty, it contributes to a number of problems that may make vaping frustrating for the device user. Some of these problems are explained below.
Vape Not Hitting: A faulty Geek Bar hit sensor will cause you not to get hits regardless of how hard you pull your draws. Sadly, there is rarely a way of fixing this, so you might just need to replace the vape with a new one.
Weak Vapor: If the sensor doesn’t send strong signals to the atomizer or mesh coils, you will get weak vapor productions even on the hardest settings and lose airflow.
Auto-Firing: Auto-fires occur when the hit sensor is stuck in an open position, causing it to continuously send signals to the coil/atomizer, thus, the device keeps firing even when you’re not making any draws.
Can You Change the Geek Bar Hit Sensor?
You can’t particularly change the sensor per se, but you can blow air into the device to clean up any debris that may have gotten the sensor stuck, thus, fixing the auto firing or weak vapor problems. However, if blowing into the device in an attempt to unclog and unstuck the sensor doesn’t work, then what you need is a new vape – you can always get one at a discounted price at Eightvape.
